The LPS8 is an open supply LoRaWAN entree. It allows you to bridge LoRa wireless network to an IP network via local area network or local area network. The LoRa wireless permits users to send information and reach extraordinarily long ranges at low data-rates.

The LPS8 uses Semtech packet forwarder and absolutely compatible with LoRaWAN protocol. It includes a SX1308 LoRa concentrator, which offer ten programmable parallel reception ways.

LPS8 has pre-configured standard LoRaWAN frequency bands to use for various countries. User also can customised the frequency bands to use in their own LoRa network.

Specifications
Hardware System:
Linux Part:
• 400Mhz ar9331 processor
• 64MB RAM
• 16MB Flash
Interface:
• 10M/100M RJ45 Ports x 1
• WiFi : 802.11 b/g/n
• LoRaWAN Wireless
• Power Input: 5V DC, 2A, Type C
• USB 2.0 host connector x 1
WiFi Spec:
• IEEE 802.11 b/g/n
• Frequency Band: 2.4 ~ 2.462GHz
Tx power:
• 11n tx power : mcs7/15: 11db mcs0 : 17db
• 11b tx power: 18db
• 11g 54M tx power: 12db
• 11g 6M tx power: 18db
Wifi Sensitivity
• 11g 54M : -71dbm
• 11n 20M : -67dbm
LoRa Spec:
• Up to -140 dBm sensitivity with SX1257 Tx/Rx front-end
• 70 dB CW interferer rejection at 1 MHz offset
• Able to operate with negative SNR, CCR up to 9dB
• Emulates 49 x LoRa demodulators and 1 x (G)FSK demodulator
• Dual digital TX & RX radio front-end interfaces
• 10 programmable parallel demodulation paths
• Dynamic data-rate (DDR) adaptation
• True antenna diversity or simultaneous dual-band operation
Features
• Open Source OpenWrt system
• Managed by Web GUI, SSH via WAN or WiFi
• Remote access with Reverse-SSH
• Emulates 49x LoRa demodulators
• LoRaWAN Gateway
• 10 programmable parallel demodulation paths
• Pre-configure to support different LoRaWAN regional settings.
• Allow to customize LoRaWAN regional parameters.
• Support Local decode ABP end node info and transfer to MQTT server
• Support different level log in.